Lennox icomfort Wi-Fi - Page 16

507341-01
16
HUMIDIFICATION SETTINGS — FEATURE SCREEN
1. From the Main Screen, touch the right arrow icon to go the the
Features screen.
2. From the Features screen, select system settings.
3. Touch the button of the humidification settings you want to adjust; if it
says humidifier OFF, one touch will display a selection for ON.
4. When you touch the set-to button, the arrows appear, allowing you to
change to the desired humidity percentage setting.
SYSTEM SETTINGS
current indoor humidity is 50%
humidifier
is ON
de-
humidifier
MEDIUM
40
%
set to
50
%
set to
ALL CHANGES MADE ON
THIS SCREEN ARE IN
STANTLY SAVED.
9:39 am Aug 15, 2012
?
Wi-Fi
OFF
MEDIUM
HIGH
humidifier
display
is ON
humidification
settings
dehumidification
settings
Figure 16. Humidification Controls
(Non-Communicating Outdoor Unit)
DEHUMIDIFICATION SETTINGS — SYSTEM DEVICES SCREEN
Pre-adjustment REQUIREMENTS
 First the device has been installed
 Second, from the “Add or Remove Non-communicating equipment?”,
touch next.
 Third, in the “Adjust a setting...” screen, configure the device as
follows:
1. In the “system devices” list, use the arrows to highlight System. Touch
edit.
2. Humiditrol
®
only—In the “System” list, use the arrows to highlight
Humiditrol Comfort Adjust. The current value defaults to Maximum
Overcooling. Touch edit.
3. Humiditrol
®
only—Touch one of the radio buttons to select the
overcooling level; touch save. (After saving, check that the current
value now shows the new selection).
4. Use arrows to highlight Min Dehumidification Setpoint; touch edit.
Note the current value (e.g. 45).
5. Use arrows to make changes; touch (After saving, check that the
current value now shows the new selection).
6. Touch the back button to return to “Adjust a setting...” screen.
DEHUMIDIFICATION SETTINGS — FEATURE SCREEN
1. From the Main Screen, touch the right arrow icon to go the the
Features screen.
2. From the Features screen, select system settings.
3. Touch the button of the dehumidification settings you want to adjust;
if it says de-humidifier OFF, one touch will display a selection for OFF,
MEDIUM or HIGH.
4. Selecting MEDIUM or HIGH will bring on the set-to button.
5. When you touch the set-to button, the arrows appear, allowing you to
change to the desired de-humidifier percentage setting.
SYSTEM SETTINGS
current indoor humidity is 50%
humidifier
is ON
de-
humidifier
MEDIUM
40
%
set to
50
%
set to
ALL CHANGES MADE ON
THIS SCREEN ARE IN
STANTLY SAVED.
9:39 am Aug 15, 2012
?
Wi-Fi
OFF
MEDIUM
HIGH
humidifier
display
is ON
(default is ON)
humidification
settings
dehumidification
settings
Figure 17. Humidifier Controls (Non-Communicating Outdoor Unit)