507341-01
48
Missing
Device Equipment Type No.
Model No. (control model no.)
Serial No. (control serial no.)
Found Compatible
Device Equipment Type No.
Model No. (control model no.)
Serial No. (control serial no.)
Settings were not copied
ADJUSTING EQUIPMENT PARAMETERS AFTER INITIAL
INSTALLER SETUP
1. From the Home Screen, touch and hold Lennox until the warning
screen appears. Press yes to continue.
2. Press equipment to change equipment parameters and edit details of
devices in the system without having to re-run the setup program.
3. Select the equipment button to continue. The system devices screen
will open. Use the arrows to select a device and touch edit.
4. Use the arrows to highlight a setting and then touch edit.
5. When finished, touch back; equipment parameters screen then touch
next. “Select tests to run screen appears"; either run tests as before
or touch skip tests.
To Previous Page
Loading...
