Lennox icomfort Wi-Fi - Page 7

iComfort Wi‐Fi
®
7-Day Programmable Communicating Thermostat
7
HOME
DS9A
Open connection (no password required)
Secure connection (password required)
(lock icon is present)
Figure 7. Typical Connection Type and Signal Strength
NOTE - The router info button provides information concerning the home
Wi-fi connection (i.e, RSSI, IP address, MAC address and wait state) all of
which may be helpful in troubleshooting network connection issues).
3. If connection is successful the screen will return to the available
networks screens. Press AP3 as exampled in figure 8 to return to the
previous screen. If the connection was successful it will be listed
connected as exampled below.
WI-FI SETTINGS
press to enable //
disable Wi-FI
9:39 am Aug 15, 2012
enabled
WI-FI
Zone 1
?
X
AP3
connected
press to change
wireless network
Must setup a network connection before registering thermostat
Wi-Fi
connection
status
Press to see
connection status
thermostat
not
registered
press to change
thermostat
registration
Figure 8. Network Connected
ESTABLISHING A WI-FI CONNECTIONS TO A HIDDEN
NETWORK
1. When connecting to a hidden network, press the add new network
icon to continue. Enter the network name (SSID). If security
encryption is enabled, then press the security is none icon. Select
either WEP, WPA or WPA2.
2. Using the on-screen keyboard, enter the password (security key). If the
network name or security key combination is incorrect or incorrectly
type, and access to the specified network failed, a message will alert
you to retry.
3. If connection is successful the screen will return to the available
networks screens. The network successfully connected will be listed
and shown as connected as exampled in figure 8.
Method 2 — Connection Status Method
1. Press connection status; this screen shows a graphical view of the
current connection status.
2. Select the router icon to choose the desire W-Fi network. When
selecting a:
 unsecured connection a screen will appear with two options,
connect and router info. Press connect to continue.
 secured connection a screen will appear requesting the Wi-Fi
network password (security key). There are two options to select
from which are connect and router info. Using the on-screen
keyboard, enter the password (security key) and then press
connect to continue.
3. If connection is successful the screen will return to the available
networks screens. Press X to return to the previous screen. If the