3
IMPORTANT!
The provided cables must be used. Do not use excessive force while pulling the
cable or when making the connections.
1. Connect controller to indoor unit main control board by inserting the plug of the
5-conductor cable into the socket provided at the indoor unit.
Indoor unit
display board
5-conductor wire
5-conductor wire
Figure 1. Wiring Connection
2. Remove the cover from the wall plate using a at-head screwdriver. See gure 2.
3. Mount the wall plate as appropriate for your application. See gure 3.
NOTE: Provide for future maintenance by allowing enough slack in the wiring to
allow the controller to be removed from the wall if needed.
Figure 2. Remove Cover from Wall Plate
To Next Page
Loading...
