Lenovo 21FA - 1060 M.2 2280 Solid-State Drive

1060 M.2 2280 solid-state drive
Attention: The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
Your computer comes with two M.2-solid-state-drive slots in total. Slot
a is under the keyboard, and slot b
is under the service door. When you configure the M.2-solid-state-drive slot in the UEFI BIOS menu, ensure
that you select the correct menu item.
• Slot
a : NVMe1
• Slot
b : NVMe2
M.2 2280 solid-state drive under the keyboard
For access, remove these FRUs in order:
• “1020 Keyboard” on page 65
• “1030 Service bracket” on page 67
Removal steps of the M.2 2280 solid-state drive under the keyboard
Chapter 9. Removing or replacing a FRU 71