Step 1. Touch the static-protective package that contains the backplane to any unpainted surface on the
outside of the server. Then, take the backplane out of the package and place it on a static-
protective surface.
Step 2. Connect the cables to the backplane.
Step 3. Put the backplane down into place.
Figure 18. Installation of backplane for four 3.5-inch hot-swap drives
a. Lean the backplane backward, align its bottom with the two pins on the front chassis base,
then align the holes on the backplane with the three pins on the front drive cage so that the
holes can pass through the two pins.
b. Close the release latches to secure the backplane in place.
Step 4. Connect the cables to the system board or expansion slots.
After you finish
1. Reinstall all the drives and drive fillers into the drive bays. See “Install a hot-swap drive” on page 38.
2. Complete the parts replacement. See “Complete the parts replacement” on page 110.
Remove the 2.5-inch rear drive backplane
Use this information to remove the 2.5-inch rear drive backplane.
About this task
Attention:
44
HR630X V2 User Guide
To Next Page
Loading...
