Figure 41. OCP 3.0 Ethernet adapter removal
Step 1. Loosen the thumbscrew that secures the adapter.
Step 2. Pull out the OCP 3.0 Ethernet adapter by its handle on the left as shown.
After you finish
Install a new OCP 3.0 Ethernet adapter or a card filler. See “Install the OCP 3.0 Ethernet adapter” on page
68.
Install the OCP 3.0 Ethernet adapter
Use this information to install the OCP 3.0 Ethernet adapter.
About this task
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the OCP 3.0 Ethernet adapter to any unpainted
surface on the outside of the server. Then, take the OCP 3.0 Ethernet adapter out of the package
and place it on a static-protective surface.
68
HR630X V2 User Guide
To Next Page
Loading...
