Chapter 4. Troubleshooting
28
Lenovo OneKey Recovery system
Where are the recovery discs?
Your computer did not come with recovery dis
cs. Use the Lenovo OneKey
Recovery system if you need to restore the system to its factory status.
What can I do if the back-up process fails?
If you can start the backup but it fails duri
ng the back-up process, try the
following steps:
1 Clo
se all open programs, and then restart the back-up process.
2 Ch
eck to see if the destination media is damaged. Select another path
and then try again.
When do I need to restore the system to its factory status?
Use this feature when the operating system fails to start up. If there is
critica
l data on the system partition, back it up before starting recovery.
BIOS setup utility
What is the BIOS setup utility?
The BIOS setup utility is ROM-based software. It displays basic computer
in
formation and provides options for setting boot devices, security,
hardware mode, and other preferences.
How can I start the BIOS setup utility?
To start the BIOS setup utility:
1 S
hut down the computer.
2 Pr
ess the Novo button and then select BIOS Setup.
How can I change the boot mode?
There are two boot modes: UEF
I and Legacy Support. To change the boot
mode, start the BIOS setup utility and set boot mode to UEFI or Legacy
Support on the boot menu.
When do I need to change the boot mode?
The default boot mode for your computer is UE
FI mode. If you need to
install a legacy operating system, such as Windows, Linux or Dos, etc (that
is, any operating system before Windows 8) on your computer, you must
change the boot mode to Legacy Support. The legacy operating system,
such as Windows, Linux or Dos, etc cannot be installed if you don't change
the boot mode.
To Next Page
Loading...
