7. In the Server Base Scenario window, select Physical Machine(Also for Fully Virtualized Guests) and
then click Next.
8. When the Installation Settings window is displayed, create a drive partition you need.
• Manually create a root partition (/)
To create a root partition, do the following:
a. Click Partitioning and select Custom Partition (for experts). Click Next.
b. In the Expert Partitioner window, select Hard Disks ➙ sda, and then click Add.
c. In the New Partitions Size window, select Custom Size.
d. Type the amount of space (in MB) in the Custom Size field and then click Next.
e. In the Formatting Options area, select Ext3 from the File system drop-down list box.
f. In the Mount partition area, select the forward slash (/) from the Mount Point drop-down list box.
g. Click Finish.
• Manually create a boot partition (/boot)
To create a boot partition, do the following:
a. In the Expert Partitioner window, select Hard Disks ➙ sda, and then click Add.
b. In the New Partitions Size window, select Custom Size.
c. Type the amount of space (in MB) in the Custom Size field and then click Next.
d. In the Formatting Options area, select FAT from the File System drop-down list box.
e. In the Mount partition area, select /boot/efi from the Mount Point drop-down list box.
f. Click Finish.
• Manually create a swap partition
To create a swap partition, do the following:
a. In the Expert Partitioner window, select Hard Disks ➙ sda, and then click Add.
b. In the New Partitions Size window, select Custom Size.
c. Type the amount of space (in MB) in the Custom Size field.
d. In the Formatting Options area, select Swap from the File system drop-down list box.
e. In the Mount partition area, select Swap from the Mount Point drop-down list box.
f. Click Finish.
Go to the Expert Partitioner window, the created root partition, boot partition, and swap partition are
displayed. Click Accept. The drive partition is finished.
9. In the Installation Settings window, click Software to select your desired software programs, and then
click OK. If the YaST window is displayed, click Accept.
10. Click Install to install the software programs that you have selected.
Notes:
• If a Warning window is displayed, select the option you desired. the following steps are based on the
scenario that Ignore this conflict of ... is selected. Do the following:
a. Click OK-TryAgain.
b. In the YaST window, click Accept.
c. In the Installation Settings window, click Install to begin the installation.
• If the YaST2 window is displayed, click Install to begin the installation.
26
ThinkServer RD650 and RD550 Operating System Installation Guide
To Next Page
Loading...
