12. The setup process continues after the server restarts. Set your root user password. Then, select Next
and press Enter. When the YaST2 window is displayed, click Yes.
Note: The password must contain at least six characters and consist of upper case letters, lower case
letters, and numbers.
13. Set your host name and domain name. Then, click Next.
14. Configure your network in the Network Configuration window. Then, click Next.
Note: If the Test Internet Connection window is displayed, configure the settings as you need. Then,
click Next.
15. In the Network Services Configuration window, click Next.
16. In the User Authentication Method window, configure the settings as you need. Then, click Next.
17. In the New LDAP User window, configure the settings as you need. Then, click Next ➙ Yes.
18. In the Release Notes window, click Next.
19. In the Hardware Configuration window, click Next.
20. In the Installation Completed window, click Finish.
21. Follow the instructions on the screen to log in to the operating system.
Installing the SUSE Linux Enterprise Server 11 operating system with
Service Pack 4
This topic provides instructions on installing the SUSE Linux Enterprise Server 11 operating system with
Service Pack 4.
To install the SUSE Linux Enterprise Server 11 operating system with Service Pack 4, do the following:
1. Insert the operating system installation disc into the optical drive that you have set as the first startup
device. Then, start the server from the optical drive.
2. In the “SUSE Linux Enterprise Server Welcome” window, depending on the SATA configuration on your
server, do one of the following:
• If your SATA configuration is set as onboard RAID, select Installation. Then press E to enter editing
mode. Modify the start parameter from linuxefi /boot/x86_64/loader/linux to linuxefi /boot/x86_
64/loader/linux brokenmosules=ahci. Then, press F10.
• If your SATA configuration is set as Add–on RAID, select Installation and then press Enter.
• If the operating system is to be installed on SAN through ISCIS/FCOE, do the following:
a. Select Installation.
b. Press E to enter editing mode. Then modify the start parameter from linuxefi/boot/x86_64/
loader/linux to linuxefi /boot/x86_64/loader/linux driverupdate=1.
c. Press F10. In the “Pls choose the Driver Update medium” window, locate the disk in which the
drive is located, and then click OK.
d. Select Back to finish loading the driver.
• If your SATA configuration is set as non-RAID, select Installation, and then press Enter.
3. In the Welcome window, select your language and keyboard layout and then select I Agree to the
License Terms. Click Next.
4. In the Media Check window, click Next to go ahead.
5. In the Installation Mode window, select New Installation, and then click Next.
6. Verify your region and time zone, and then click Accept ➙ Next.
Chapter 2. Installing an operating system in UEFI mode 25
To Next Page
Loading...
