e. When the Driver Disk Source window is displayed again, click OK.
f. In the Select driver disk image window, select your desired driver and then click OK.
g. When “Do you wish to load any more driver disks?” is displayed, select NO.
3. When the Disk Found window is displayed, select Skip and then press Enter.
Note: If the operating system is installed on the SAN card through iSCSI, the Networking Device
window is displayed. Select the desired Ethernet device, and then click OK. In the Configure TCP/IP
window, select the option according to the network environment. The following steps are based on the
scenario that Enable lpv4 support->Dynamic IP configuration (DHCP) is selected.
4. In the RED HAT window, click Next.
5. Select the language that you want to use during the installation process and click Next.
6. Select the appropriate keyboard layout for the system and click Next.
7. Select the type of devices that are involved in the installation, and then click Next.
Notes:
• If the Storage Device Warning window is displayed, click Yes, discard any data. If the message “At
least one existing installation has been detected on your system. What would you like to do?” is
displayed, select the option as you desired and then click Next.
• If the operating system is to be installed on the SAN card through an iSCSI card, select Specialized
Storage Devices, and then click Next. When the message “Please select the drives you’d like to
install the operating system on...” is displayed, select Remote SAN in Other SAN Devices window,
and then click Next.
• If the operating system is to be installed on the SAN card through an FCOE card, select Specialized
Storage Devices, and then click Next. When the message “Please select the drives you’d like to
install the operating system on...” is displayed, select SAN disk in Basic Devices window, and then
click Next.
8. Type a name for your server. Then, click Next.
9. Specify your time zone by selecting the nearest city in your time zone. Then, click Next.
10. Personalize the server by typing the root password for the root user account. Then, click Next.
Note: If a message prompts you that the password is weak, click Use Anyway.
11. In the Which type of the installation would you like window, select your desired option. The following
steps are based on the scenario that Create Custom Layout is selected in this step.
12. By default, a partition is already selected for you to install the operating system. If you want to create a
partition manually, select the option as you need and then click Next.
13. In the Please Select A Device window, do one of the following to create a partition and then click Next.
• Manually create a root partition (/)
To create a root partition, do the following:
a. Click Create. The Create Storage window is displayed.
b. Select Standard Partition and then click Create.
c. In the Add Partition window, select the forward slash (/) from the Mount Point drop-down list box.
d. Select Ext4 from the File System Type drop-down list box.
e. In the Allowable Drives window, choose the hard disk drive to install the operating system.
f. Type the amount of space (in MB) in the New Partitions Size window and then click OK.
• Manually create a boot partition (/boot)
To create a boot partition, do the following:
Chapter 3. Installing an operating system in legacy mode 77
To Next Page
Loading...
