13
Installing the Broadcom 9560-16i RAID Adapter
To install the Broadcom Adapter in PX follow the below steps:
1. Remove both side covers from the system.
2. Install NVMe enclosures in the front access bay(s). For instructions on installing
the M.2 NVMe and E1.S Front Access Bay enclosures, please refer to the PX
Storage Whitepaper.
Note: The instructions in the whitepaper are for installing M.2 enclosures. These
are the same instructions for installing E1.S enclosures. If you are installing
U.2/U.3 Front Access Bay enclosures, you can find detailed guidance in the
previous section “Installing U.2/U.3 Front Access Enclosure in PX”.
3. Guide the Broadcom NVME Bay2/Bay3 Gen4 cables from front access bay
enclosures 2+5 & 3+6 to the backside of the motherboard and connect the cables
as seen below.
Note: Only drives in Bay 2+5 and/or Bay 3+6 are capable of supporting a
Broadcom adapter.
To Next Page
Loading...
