8
Installing U.2/U.3 Front Access Enclosures in PX
On ThinkStation PX models without Front U.2/U.3 SSD Enclosures installed previously,
the user has an option to add up to two (2) U.2/U.3 SSD Enclosures in the front access
bays. Below are instructions on how to install U.2/U.3 Enclosures in the front access
bays.
1. Remove the Front Access 3.5” HDD Tray from ‘Front Access Bay 2’ and/or ‘Front
Access Bay 3’ depending on the number of front U.2/U.3 NVMe enclosures to be
installed.
Note: Some ThinkStation PX models may have the Front Access Bay Key Lock
installed. If so, make sure the front access bays are unlocked during this process.
For instructions on how to unlock Front Access Bay Key Lock, please refer to the
Thinkstation PX Storage Whitepaper.
2. Remove the chassis side cover (left).
Note: Some ThinkStation PX models may have the chassis side cover key lock
installed. If so, make sure the chassis side cover is unlocked. On how to unlock
Side cover key lock, please refer to the Thinkstation PX Storage Whitepaper.
To Next Page
Loading...
