(1) Host interface card (HIC)
(2) Thumbscrews
5.
Hand-tighten the HIC thumbscrews.
Do not use a screwdriver, or you might over-tighten the screws.
6.
Using a #1 Phillips screwdriver, attach the new HIC faceplate to the controller canister with the
four screws you removed previously.
6.3.5. Step 5: Reinstall controller canister
After installing the new HIC, reinstall the controller canister into the controller shelf.
Steps
1.
Reinstall the cover on the controller canister by sliding the cover from back to front until the
button clicks.
2.
Turn the controller canister over, so that the removable cover faces down.
3.
With the cam handle in the open position, slide the controller canister all the way into the
controller shelf.
The following figure is an example of a DE6000H (2U24) controller shelf:
112
To Next Page
Loading...
