Steps
1.
Check the Power LED and the Attention LED on the drive you replaced. (When you first insert a
drive, its Attention LED might be on. However, the LED should go off within a minute.)
◦ Power LED is on or blinking, and the Attention LED is off: Indicates that the new drive is
working correctly.
◦ Power LED is off: Indicates that the drive might not be installed correctly. Remove the drive,
wait 30 seconds, and then reinstall it.
◦ Attention LED is on: Indicates that the new drive might be defective. Replace it with another
new drive.
2.
If the Recovery Guru in ThinkSystem System Manager still shows an issue, select Recheck to
ensure the problem has been resolved.
3.
If the Recovery Guru indicates that drive reconstruction did not start automatically, start
reconstruction manually, as follows:
Perform this operation only when instructed to do so by technical support or
the Recovery Guru.
a.
Select Hardware.
b.
Click the drive that you replaced.
c.
From the drive’s context menu, select Reconstruct.
d.
Confirm that you want to perform this operation.
When the drive reconstruction completes, the volume group is in an Optimal state.
4.
As required, reinstall the bezel.
5.
Return the failed part to Lenovo, by following all packaging instructions and using any
packaging materials that are provided.
5.3.5. What’s next?
Your drive replacement is complete. You can resume normal operations.
5.4. Replace DE6000H drive drawer (60-drive)
You can replace a drive drawer in a DE6000H array.
About this task
The steps to replace a failed drive drawer in a DE6000H (4U60) controller shelf or a DE600S drive
shelf depend on whether the volumes in the drawer are protected by Drawer Loss Protection. If all
volumes in the drive drawer are in disk pools or volume groups that have Drawer Loss Protection,
you can perform this procedure online. Otherwise, you must stop all host I/O activity and power off
the shelf before replacing the drive drawer.
69
To Next Page
Loading...
