4.
Slide the drive drawer into the slot, and ensure that the drawer guide slides under the lock-out
tumbler.
Risk of equipment damage — Damage occurs if the drawer guide does not
slide under the lock-out tumbler.
5.
Carefully push the drive drawer all the way in until the latch fully engages.
Experiencing a higher level of resistance is normal when pushing the drawer closed for the first
time.
Risk of equipment damage — Stop pushing the drive drawer if you feel
binding. Use the release levers at the front of the drawer to slide the drawer
back out. Then, reinsert the drawer into the slot, ensure the tumbler is above
the rail, and the rails are aligned correctly.
5.4.5. Step 5: Attach cable chains
Attach the cable chains so you can safely re-install the drives in the drive drawer.
When attaching a cable chain, reverse the order you used when disconnecting the cable chain. You
must insert the chain’s horizontal connector into the horizontal guide rail in the enclosure before
inserting the chain’s vertical connector into the vertical guide rail in the enclosure.
Steps
1.
Make sure that:
◦ You completed the step to install the new drive drawer.
◦ You have two replacement cable chains, marked as LEFT and RIGHT (on the horizontal
connector next to the drive drawer).
2.
From the back of the drive shelf, remove the fan canister on the right side, and set it aside.
3.
If the shelf is powered on, ensure that the left fan goes to its maximum speed.
Possible equipment damage due to overheating — If the shelf is powered
on, do not remove both fans at the same time. Otherwise, the equipment
might overheat.
4.
Attach the right cable chain:
a.
Locate the horizontal and vertical connectors on the right cable chain and the
corresponding horizontal guide rail and vertical guide rail inside the enclosure.
b.
Align both cable chain connectors with their corresponding guide rails.
c.
Slide the cable chain’s horizontal connector onto the horizontal guide rail, and push it in as
far as it can go.
82
To Next Page
Loading...
