Lenovo ThinkSystem HR630X - Page 40

© Copyright Lenovo 2017
40


color,functionkeys,etc.VT‐UTF8:UsesUTF8
encodingtomapUnicodecharsonto1ormore
bytes.
Bitspersecond 9600/19200/38400/576
00/115200
Selectsserialporttransmissionspeed.Thespeed
mustbematchedontheotherside.Longornoisy
linesmayrequirelowerspeeds.
DataBits 7/8 DataBits
Parity None/Even/Odd/Mark/S
pace
Aparitybitcanbesentwiththedatabitstodetect
sometransmissionerrors.Even:paritybitis0ifthe
numof1'sinthedatabitsiseven.Odd:paritybitis
0ifnumof1'sinthedatabitsisodd.Mark:parity

bitisalways1.Space:Paritybitisalways0.Mark
andSpaceParitydonotallowforerrordetection.
Theycanbeusedasanadditionaldatabit.
StopBits 1/2 Stopbitsindicatetheendofaserialdatapacket.(A
startbitindicatesthebeginning).Thest andard
settingis1stopbit.Communicationwithslow
devicesmayrequiremorethan1stopbit.
FlowControl None/
HardwareRTS/CTS
Flowcontrolcanpreventdatalossfrombuffer
overflow.Whensendingdata,ifthereceiving
buffersarefull,a'stop'signalcanbesenttostop
thedataflow.Oncethebuffersareempty,a'sta rt'
signalcanbesenttore‐starttheflow.Hardware

flowcontrolusestwowirestosendstart/stop
signals.
VT‐UTF8ComboKey
Support
Disabled/Enabled EnableVT‐UTF8CombinationKeySupportfor
ANSI/VT100terminals
RecorderMode Disabled/Enabled Withthismodeenabledonlytextwillbesent.This
istocaptureTerminaldata.
Resolution100x31 Disabled/Enabled Enablesordisablesextendedterminalresolution
LegacyOSRedirection
Resolution
80x24/80x25 OnLegacyOS,theNumberofRowsandColumns
supportedredirection
PuttyKeyPad VT100/LINUX/XTERMR6/
SCO/ESCN/VT400
SelectFunctionKeyandKeyPadonPutty.
RedirectionAfterBIOS
POST
Always
Enable/BootLoader
TheSettingsspecifyifBootLoaderisselectedthen
Legacyconsoleredirectionisdisabledbefore
bootingtoLegacyOS.DefaultvalueisAlways
EnablewhichmeansLegaacyconsoleRedirectionis
enabledforLegacyOS.
OneBlankLine