Table 14. BMC settings settings
Item
Options
Description
Power Restore Policy
• Always Off
• Restore
• Always On
Determine the mode of operation after loss of power.
[Always Off]: System remains off upon power restore.
[Restore]: System restores to the state it was before
power failed. [Always On]: System turns on upon power
restore. Allow a few minutes for the changes to take
effect. Always Off is the default setting.
Note: This option is configuration dependent, and this
item could not use Setup load default to back to default
value.
Ethernet over USB interface
• Enable
• Disable
[Enable] for using the xClarity Essentials in-band update
utility. [Disable] will prevent xClarity Essentials and other
applications that are running on the server from
requesting the BMC to perform tasks. Enable is the
default setting.
Network Settings N/A Configure the network of the management controller.
Reset Factory Defaults Setting N/A Restore all management controller settings to factory
defaults, including network configuration and credentials,
the management controller will be restarted automatically.
Restart BMC N/A Restart the BMC.
46 ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual
To Next Page
Loading...
