Lenovo ThinkSystem SD530 - Page 51

Network settings
Item
Options
Description
Network Interface Port
• Dedicated
• Shared
Select the System Management Network Interface Port.
Dedicated is the default setting.
Note: This option is configuration dependent.
Shared NIC on
1. ML2 Card
2. PHY Card
3. Onboard Port 1
Select the shared NIC port.
Note: This item is only on when network interface port is
on Shared, and this option is configuration dependent.
Fail-Over Rule
• None
• Failover to shared
(Optional Card
ML2)
• Failover to shared
(Optional Card
PHY)
• Failover to shared
(Onboard Port)
Setting to control Fail-Over types allowed. None is the
default setting.
Note: This item is only on when network interface port is
on Shared, and this option is configuration dependent.
Burned-in MAC Address N/A
Hostname N/A Change the host name. The new name should be within 1
to 63 characters.
DHCP Control
• Static IP
• DHCP Enabled
• DHCP with
Fallback
Configure DHCP Control or manually configure a static IP
address. Fallback will use static IP address if DHCP fails.
Select Static to enter IPV4 address manually. DHCP with
Fallback is the default setting.
IP Address
x.x.x.x
Enter IP address in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
Subnet Mask
x.x.x.x
Enter Subnet Mask in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
Default Gateway
x.x.x.x
Enter Default Gateway in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
IP6
• Enable
• Disable
Enable/Disable IPv6 support on management port.
Enable is the default setting.
Chapter 3. System configuration and boot management 47