Table 15. Parts list (continued)
Index Description Type
25
2.5-inch to 3.5-inch drive adapter T1
26
2.5-inch hot-swap drive backplane T1
27
Front door T1
28
Chassis T1
29
PCIe adapter
T1
30
Rear system fan T1
31
RAID flash power module holder T2
32
RAID flash power module T1
33
Memory module T1
34
Intrusion switch T1
35
CMOS battery (CR2032) C
36
M.2 drive T1
37
M.2 boot adapter T1
38
PCIe adapter for M.2 boot adapter
T1
39
5.25-inch Optical drive filler cover and optical drive
filler
T1
Power cords
Several power cords are available, depending on the country and region where the server is installed.
To view the power cords that are available for the server:
1. Go to:
http://dcsc.lenovo.com/#/
2. Click Preconfigured Model or Configure to order.
3. Enter the machine type and model for your server to display the configurator page.
4. Click Power ➙ Power Cables to see all line cords.
Notes:
• For your safety, a power cord with a grounded attachment plug is provided to use with this product. To
avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
• Power cords for this product that are used in the United States and Canada are listed by Underwriter's
Laboratories (UL) and certified by the Canadian Standards Association (CSA).
• For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a
minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length and a parallel
blade, grounding-type attachment plug rated 15 amperes, 125 volts.
• For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length
and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
Chapter 3. Parts list 41
To Next Page
Loading...
