Service Label and QR code
In addition, the system Service Label is located on the inside surface of the server cover, provides a quick
reference (QR) code for mobile access to service information. You can scan the QR code with a mobile
device using a QR code reader application and get quick access to the Service Information web page. The
Service Information web page provides additional information for parts installation and replacement videos,
and error codes for solution support.
Figure 23. Service Label and QR code
Server setup checklist
Use the server setup checklist to ensure that you have performed all tasks that are required to set up your
server.
The server setup procedure varies depending on the configuration of the server when it was delivered. In
some cases, the server is fully configured and you just need to connect the server to the network and an AC
power source, and then you can power on the server. In other cases, the server needs to have hardware
options installed, requires hardware and firmware configuration, and requires an operating system to be
installed.
The following steps describe the general procedure for setting up a server.
Chapter 4. Unboxing and setup 45
To Next Page
Loading...
