Chapter 3. 3-6
Installing the monitor driver in Windows 11
To use the Plug and Play feature in Microsoft Windows 11, do the following:
1. Turn off the computer, all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow your computer to start the
Windows 11 operating system.
4. From the Lenovo website https://pcsupport.lenovo.com/solutions/e22_30, find
the corresponding monitor driver and download it to a PC to which this monitor is
connected (such as a desktop).
5. Open the Display Properties window by clicking Start, Control Panel and Hardware
and Sound icon. and then clicking the Display icon.
6. Click the Change the display settings tab.
7. Click the Advanced Settings icon.
8. Click the Monitor tab.
9. Click the Properties button.
10. Click the Driver tab.
11. Click Update Driver, then click Browse the computer to find the driver program.
12. Select Pick from the list of device driver program on the computer.
13. Click the Hard Disk button. By clicking the Browse button, browse and point to the
following path:
X:\Monitor Drivers\Windows 11
(where X indicates “the folder in which the downloaded driver is located” (such as a
desktop)).
14. Select the “len E22-30.inf” file and click the Open button. Click the OK button.
15. In the new window, select LEN E22-30 and click Next.
16. After the installation is complete, delete all downloaded files and close all windows.
17. Restart the system. The system will automatically select the maximum refresh rate
and corresponding Color Matching Profiles.
Note: On LCD monitors, unlike CRTs, a faster refresh rate does not improve display
quality. Lenovo recommends using either 1920 x 1080 at a refresh rate of 60 Hz, or
640 x 480 at a refresh rate of 60 Hz.
Getting further help
If you still can’t solve your problem, please contact the Lenovo Support Center. For
more information on contacting the Support Center, please see Appendix A.”Service
and Support”on page A-1
To Next Page
Loading...
