Lenze 9300 vector - Changing and Saving Parameters

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
3
 17
EDKVF93−05 EN 2.0
Function keys
 Note!
Shortcuts with :
Press and hold , then press the second key in addition.
Key
Function
Menu level Code level Parameter level Operating level

Change to the
parameter level
Change to the operating
level
Change to the code
level

Go to the "Short setup"
menu and load
predefined
configurations
1)
Accept parameters
when SHPRG  or
SHPRG is displayed


Change between menu
items
Change of code number
Change of digit via
cursor

 
Quick change between
menu items
Quick change of code
number
Quick change of digit
via cursor
!
Change between main menu, submenu and code
level
Cursor to the right
"
Cursor to the left
#
Deactivate the function of the key $, the LED in the key goes off
$
Inhibit the controller, the LED in the key is lit.
Reset fault (TRIP−Reset): 1. Remove the cause of malfunction
2. Press $
3. Press #
1)
Only active for operation with standard devices of the 8200 vector or 8200 motec series
3.1.4 Changing and saving parameters
 Note!
Your settings have an effect on the current parameters in the main memory.
You must save your settings in a parameter set so that they are not lost when
the mains are connected.
If you only need one parameter set, save your settings as parameter set 1,
since parameter set 1 is loaded automatically after mains connection.
Step Key
sequence
Action
1. Select the menu   ! " Use the arrow keys to select the desired menu
2. Change to the code level ! Display of the first code in the menu
3. Select code or subcode   Display of the current parameter value
4. Change to the parameter level 
5. When SHPRG is displayed, inhibit the
controller
$
1)
The drive coasts
6. Change parameter
A ! " Move cursor below the digit to be changed
B   Change of digit
 
 
Quick change of digit
7. Accept the changed parameter