Need help?Do you have a question about the Lenze 8200 vector series and is the answer not in the manual?
General| Category | DC Drives |
|---|---|
| Overload capacity | 150% for 60 seconds |
| Protection class | IP20 |
| Mains voltage | 380V to 480V AC |
| Control method | Vector control |
| Communication options | CANopen |
| Protection features | Overcurrent, overvoltage, undervoltage, overtemperature, short circuit |
| Humidity | ≤ 95% relative humidity, non-condensing |
| Series | 8200 vector |
Provides guidance on designing and installing 8200 vector frequency inverters, focusing on EMC compatibility.
Defines key terms and abbreviations used throughout the document for clarity.
Covers general safety, application, transport, storage, and handling notes for Lenze controllers.
Details potential residual hazards, including electrical, thermal, and operational risks associated with controllers.
Explains the standardized format for safety information, including pictographs, signal words, and warnings.
Outlines fundamental principles for EMC-compliant installation, including shielding, earthing, and cable routing.
Details EMC measures for power connections, including RFI filters for 230 V and 400 V mains.
Covers EMC-compliant wiring for analog and digital control signals, focusing on shielded cables.
Explains EMC considerations for wiring the relay output, applicable to control signals and mains potentials.
Describes EMC-compliant wiring for PTC input terminals used for motor temperature monitoring.
Covers EMC wiring guidelines for accessories like mains chokes, brake resistors, and DC-bus systems.
To Next Page
