Lenze 8200 vector series User Manual

This documentation is only valid for 8200 vector controllers as of version:
c d e
E82xV xxx K x C xxx 3x 3x
Type
E = Built-in unit
D = Push-through technique
C=Coldplate
Power
(e.g.152=15× 10
2
W=1.5kW)
(e.g.113=11× 10
3
W=11kW)
Voltage class
2 = 230 V
4 = 400 V/500 V
Version, variant
0xx = EMC filter integrated
2xx = Without EMC filter
x0x = Without function ”Safe standstill”
x4x = With function ”Safe standstill” (3 ... 11 kW)
xx0 = Not coated
xx1 = Coated
Hardware version
Software version
© 2003 Lenze Drive Systems GmbH
Without written approval of Lenze Drive Systems GmbH no part of these Instructions must be copied or given to third parties.
All information given in this documentation has been selected carefully and comply with the hardware and software described. Nevertheless, deviations
cannotbe ruledout. Wedo nottake any responsibilityor liabilityfor damageswhich might possiblyoccur.We willinclude necessarycorrections in subsequent
editions.
Version 3.0 10/2003
Inverter
Input:
Output:
8200 vector
Type:
_
K
For detailed information refer to the manual
EDK82EV222
Id.-No:
Made in Germany
1D74
IndustrialControl Equipment
D-31855 Aerzen
Hans-Lenze-Str. 1
Prod.-No:
Ser.-No:
Version:
 

55 Aerzen
Ser.-No:
Version:
 

Lenze 8200 vector series Specifications

General

Category	DC Drives
Overload capacity	150% for 60 seconds
Protection class	IP20
Mains voltage	380V to 480V AC
Control method	Vector control
Communication options	CANopen
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature, short circuit
Humidity	≤ 95% relative humidity, non-condensing
Series	8200 vector