Lenze 8200 vector series - Default Chapter; Table of Contents

Contents
1
l EDBEMV82EV EN 3.0
1Preface 2.............................................................
1.1 About these Instructions 2.........................................................
1.2 Terminology used 2..............................................................
2 Safety instructions 4....................................................
2.1 Safety and application notes for Lenze controllers 4......................................
2.3 Residual hazards 7..............................................................
2.4 Layout of the safety instructions 8...................................................
3 Wiring according to EMC (structure of a CE-typical drive system) 9...............
3.1 Basic rules 9...................................................................
3.1.1 Installatio n in the control cabinet 10..........................................
3.1.2 Specificati on of the cables used 10...........................................
3.1.3 Shield connection 10.....................................................
3.1.4 Earthing 11............................................................
3.1.5 Wiring on the mains side 11................................................
3.1.6 Wiring on the motor side 12................................................
3.2 Power connections 14.............................................................
3.2.1 230 V mains 15.........................................................
3.2.2 400 V mains 18.........................................................
3.3 Control connections 20............................................................
3.3.1 Basic rules for wiring 20...................................................
3.4 Relay output 21.................................................................
3.4.1 Basic rules for wiring 21...................................................
3.4.2 Wiring 21..............................................................
3.5 PTC input 22....................................................................
3.5.1 Basic rules for wiring 22...................................................
3.5.2 Wiring 22..............................................................
3.6 Accessories 23..................................................................
3.6.1 Mains choke 23.........................................................
3.6.2 Brake resistor 24........................................................
3.6.3 DC-bus system 25.......................................................
4 Recognising and eliminating EMC interferences 26.............................