Lenze 8200 vector series User Manual

Wiring according to EM C
Relay output
21
l EDBEMV82EV EN 3.0
3.4 Relay output
This chapter describes the wiring according to EMC of the relay output. With the relay output the
controller switches control signals and mains potentials. Information on the switching capacity is
given in the Technical Data of the basic device.
3.4.1 Basic rules for wiring
z For switching the control signals the rules for the wiring of control connections apply (see
chapter 3.3.1).
z For switching the mains potentials wiring with unshielded cables is sufficient.
3.4.2 Wiring
8200vec013
Fig. 8 Wiring of relay output
Function Relay position set Message
(Lenze setting)
X1.2/K11 Relay output NC contact open TRIP
X1.2/K12 Relay middle contact
X1.2/K14 Relay output NO contact closed TRIP
PES HF-shield end by PE connection through shield clamp.

Lenze 8200 vector series Specifications

General

Category	DC Drives
Overload capacity	150% for 60 seconds
Protection class	IP20
Mains voltage	380V to 480V AC
Control method	Vector control
Communication options	CANopen
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature, short circuit
Humidity	≤ 95% relative humidity, non-condensing
Series	8200 vector