What to do if I get a 'FILE VER INCOMP!' error on my Lenze Motherboard?
The 'FILE VER INCOMP!' error on your Lenze Motherboard indicates that the parameter file or servo EPM you're trying to edit has a different parameter version than the configuration file of the EPM programmer. To resolve this, ensure that the parameter version corresponds to the configuration file of the EPM programmer.
Why does my Lenze EPM Programmer EEPM1RA Motherboard say 'CHANGE BATTERY!'?
The 'CHANGE BATTERY!' message on your Lenze Motherboard indicates that the battery voltage is below 3.6V. You should change the batteries.
Identifies and describes parts like Display, MASTER PORT, EPM PORT, and Operator Keypad.
Details the function of each key (ON, OFF, MENU, ENTER, UP/DOWN, BACK LIGHT, COPY TO EPM).
Step-by-step instructions for powering on/off, with and without password.
Direct parameter file copy from one EPM to another via MASTER/EPM PORT.
How to copy a saved parameter file from the programmer to an EPM.
For Servo products, allows editing PPP BAUDRATE, NETWORK ADDRESS, etc.
Procedures for setting or changing the access protection password.
Lists display errors, their causes, and remedies, spanning pages 22-23.
General| Brand | Lenze |
|---|---|
| Model | EPM Programmer EEPM1RA |
| Category | Motherboard |
| Language | English |
To Next Page