Lenze EPM Programmer EEPM1RA - Copying Programmer File to EPM

13
ENGLISH
Operation
4.8 Copy a file stored in the Programmer to an EPM
With this function it is possible to copy a parameter file saved in the EPM programmer to an EPM.
• Plug the EPM, to which you want to copy the parameter file, into the EPM PORT.
Press The display shows... Explanation
1.
MENU
FILE –> EPM
Press the key until the menu appears in the display.
2.
ENTER
#DEFAULTS(400)>>
The stored name of a parameter file (e.g. DEFAULTS)
stored in the EPM programmer, is displayed.
3.
ENTER
#DEFAULTS(400
)
>>
The cursor is blinking in the display on the right.
4.
#ABC_ _ _ _ _(400
)
>>
Select the parameter file you want to copy (e.g.
ABC_ _ _ _ _).
5.
COPY
TO EPM
TRANSFERRING 0%
The parameter file is copied or..
DAT=400 EPM=312
...if the parameter version of the file does not
correspond with the parameter version of the EPM
in the EPM PORT,...
CONFIRM= [ENTER]
...a security check takes place concerning the
existing data on the EPM:
Press the ENTER key to overwrite the existing data.
Press the MENU key, if you want to abort the
process.
6.
ENTER
TRANSFERRING 100%
#ABC_ _ _ _ _(400)>>
The parameter file will be copied.
7.
MENU
FILE –> EPM
Returns to the main menu.