EasyManua.ls Logo

Lenze ESV251 1S Series - Table of Contents

Lenze ESV251 1S Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Lenze SMVector 13554876 EDBSV01 EN v21.0
About these Instructions............................................................................................................2
1 Safety Information ...............................................................................................................3
2 Technical Data ...................................................................................................................... 7
2.1 Standards and Application Conditions ........................................................................7
2.2 SMV Type Number Designation ..................................................................................8
2.3 Ratings ........................................................................................................................ 9
3 Installation .......................................................................................................................... 12
3.1 Dimensions and Mounting ........................................................................................12
3.1.1 NEMA 1 (IP31) Models < 30HP (22kW) .......................................................12
3.1.2 NEMA 1 (IP31) Models > 30HP (22kW) .......................................................13
3.1.3 NEMA 4X (IP65) Models ...............................................................................14
3.1.4 NEMA 4X (IP65) Models with Disconnect Switch ......................................... 15
3.2 Electrical Installation .................................................................................................16
3.2.1 Power Connections ......................................................................................16
3.2.1.1 Mains Connection to 120VAC Single-Phase Supply ....................16
3.2.1.2 Mains Connection to 240VAC Single-Phase Supply ....................17
3.2.1.3 Mains Connection to Three-Phase Supply ...................................17
3.2.1.4 Motor Connection .........................................................................17
3.2.1.5 Installation Recommendations for EMC Compliance ...................18
3.2.1.6 NEMA 4X (IP65) Input Terminal Block .......................................... 18
3.2.1.7 Dynamic Brake Connections ........................................................19
3.2.2 Fuses/Cable Cross-Sections ........................................................................20
3.2.3 Control Terminals ..........................................................................................21
4 Commissioning .................................................................................................................. 23
4.1 Local Keypad & Display ............................................................................................ 23
4.2 Drive Display and Modes of Operation .....................................................................25
4.3 Parameter Setting ..................................................................................................... 26
4.4 Electronic Programming Module (EPM)....................................................................26
Copyright © 2013 - 2006 Lenze Americas Corporation
All rights reserved. No part of this manual may be reproduced or transmitted in any form without written permission
from Lenze Americas Corporation. The information and technical data in this manual are subject to change without
notice. Lenze Americas Corporation makes no warranty of any kind with respect to this material, including, but not
limited to, the implied warranties of it’s merchantability and fitness for a given purpose. Lenze Americas Corporation
assumes no responsibility for any errors that may appear in this manual.
All information given in this documentation has been carefully selected and tested for compliance with the hardware and
software described. Nevertheless, discrepancies cannot be ruled out. We do not accept any responsibility nor liability
for damages that may occur. Any necessary corrections will be implemented in subsequent editions.
This document printed in the United States.
Contents

Table of Contents

Related product manuals