Lenze ESV251 1S Series - Quick Start Parameter Settings; Basic Parameter Settings

64 Lenze SMVector 13554876 EDBSV01 EN v21.0
SMV Quick Start Guide
Code Possible Settings
IMPORTANT
No. Name Default Selection
P100
Start Control
Source
0
0 Local keypad
Run/stop button on front of drive
(default no change necessary out of box)
P101
Standard
Reference Source
0
0 Keypad
Speed/torque reference from keypad buttons
(default no change necessary out of box)
P102
Minimum Output
Frequency
0
Set this to the minimum frequency
you need for the application
P103
Maximum Output
Frequency
60
Set this to the maximum frequency
you need for the application
P104
Acceleration Time 20s
Set the required acceleration time
needed for the application
P105
Deceleration Time 20s
Set the required deceleration time
needed for the application
P108
Motor Overload
Protection
100%
Calculate P108 = (motor rated
current/SMV output current rating
x100 (found on pages 9-11)
This parameter is used to protect your motor and
controls. Full load amp rating of the motor should
match the output amperage rating of the motor.
Going below 30% is not recommended (i.e. 3amp
motor and 10amp drive).
P165
Base Voltage
Base voltage and base frequency are the main
parameters for scaling the V/Hz curve (see
graphic on right). The base voltage (P165)
is the AC voltage output voltage at the drive’s
base frequency (P167). For a typical setup
in the US, this comes with default values for
whatever voltage the drive’s rated for to run a
60Hz motor that provides full output voltage
based on the incoming line voltage minus
some loses.
P167
Base Frequency
1.1 Quick Start Parameter settings
1.1.1 Basic Parameter settings
The SMVector drives can run a motor right out of the box using the onboard Keypad! Below are a few
parameters that should be considered when trying to run using the onboard keypad.
U
F
100%
P168
P167