Parameter setting
7-1
BA9300SU EN 2.1
7 Parameter setting
• The parameter setting of the controller is used to adapt the drive to your applications.
• The complete parameter set is organised in codes which are consecutively numbered and
begin with ”C”.
(see code table, chapter 11.3).
• You can save the parameter set of an application.
– Four parameter sets are available so that the controller can be adjusted rapidly from one
application to another.
– When delivered, the parameter sets are factory-set.
7.1 Ways of parameter setting
There are two ways of changing parameters:
• Using the keypad
• Using a superimposed host (PC or PLC) via fieldbus modules and operating programs (see
accessories chapter 11.1).
In these Operating Instructions, only the change of parameters using the keypad is described.
To Next Page
Loading...
