Lenze EVS9323-ES - Page 8

Contents
iii
 BA9300SU EN 2.1
6 During operation 6-1.......................................................
6.1 Status indications 6-1................................................................
6.1.1 In Global Drive Control 6-1......................................................
6.2 Information on operation 6-2...........................................................
6.2.1 Switching on the motor side 6-2..................................................
6.2.2 Controller protection by current derating 6-3.........................................
7 Parameter setting 7-1......................................................
7.1 Ways of parameter setting 7-1..........................................................
7.1.1 Structure of a parameter set 7-2.................................................
7.1.2 List of selection menus 7-3.....................................................
7.2 Parameter setting using the keypad 7-7...................................................
7.2.1 Keypad 7-7.................................................................
7.2.2 Change parameters 7-10........................................................
7.2.3 Save parameter set 7-11........................................................
7.2.4 Load parameter set 7-12........................................................
7.2.5 Parameter set transfer 7-14......................................................
7.2.6 Password protection 7-16.......................................................
7.3 Display functions 7-16.................................................................
8 Configuration 8-1..........................................................
8.1 Predefined configurations 8-1...........................................................
8.1.1 Working with predefined configurations 8-1.........................................
8.2 Operating modes 8-2.................................................................
8.2.1 Parameter setting 8-2.........................................................
8.2.2 Control 8-2.................................................................
8.2.3 Configuration with Global Drive Control 8-3..........................................
8.3 Working with function blocks 8-4........................................................
8.3.1 Signal types 8-4.............................................................
8.3.2 Elements of a function block 8-5.................................................
8.3.3 Connection of function blocks 8-6................................................
8.3.4 Entries into the processing table 8-10..............................................
8.4 Description of function blocks 8-12........................................................
8.5 Monitoring 8-15......................................................................
8.5.1 Reactions 8-15...............................................................
8.5.2 Set reactions 8-16.............................................................
8.5.3 Monitoring functions 8-17.......................................................
8.5.4 Fault indication via digital output 8-18..............................................