Lenze Global Drive 8200 motec Series

Parameter setting
Parameter setting using the keypad
6
l
EDK82MVXXX EN 1.0
2 Parameter setting
2.1 Parameter setting using the keypad
The keypad is available as accessory. A full description can be obtained from the information
included in the keypad delivery.
0 Function keys
1 Status display
2 Bargraph display
3 Function bar 1
4 Function bar 2
5 Parameter set
6 Code number
Changes possible when
7 Subcode number
C
h
a
n
g
e
s
p
o
s
s
i
b
l
e
w
h
e
n
lamp is blinking
8 Parameter value with unit
2.1.1 Menu structure
All parameters for controller setting or monitoring are saved in codes under the menus User and all.
The codes have numbers 6 and are abbreviated in the text with a ”C” before the number. Some
codes store the parameters in numerical “subcodes” 7 to ensure that parameter setting is clearly
structured (example: C0517 menu User).
• The menu User
– is active after every mains switching or keypad attachment during operation.
– contains all codes for a standard application with linear V/f characteristic control (Lenze
setting).
– can be modified as required under C0517.
• The menu all
– contains all codes.
– shows a list of all codes in ascending order.
• The change between User and all and how to change parameters in the codes is described
on the following pages.
efesotomasyon.com - Lenze
Show/Hide Bookmarks