Lenze i55 Series - Page 14

14.15 Conguraon of digital outputs 603
14.15.1 Relay 603
14.15.2 Digital output 1 607
14.15.3 Digital output 2 608
14.15.4 NetWordOUT1 status word 609
14.15.5 HTL output 612
14.15.5.1 Example 1: Pulse train 0 ... 10 kHz ≡ output frequency 0 ... 100 Hz 615
14.15.5.2 Example 2: Pulse train 2 ... 10 kHz ≡ output frequency 30 ... 60 Hz 616
14.16 Conguraon of analog outputs 617
14.16.1 Analog output 1 617
14.16.1.1 Example 1: Output voltage 0 ... 10 V ≡ output frequency 0 ... 100 Hz 619
14.16.1.2 Example 2: Output voltage 2 ... 10 V ≡ output frequency 30 ... 60 Hz 619
14.16.2 Analog output 2 620
15 Technical data 622
15.1 Standards and operang condions 622
15.1.1 Conformies/approvals 622
15.1.2 Protecon of persons and device protecon 622
15.1.3 EMC data 622
15.1.4 Motor connecon 623
15.1.5 Environmental condions 623
15.1.6 Electrical supply condions 623
15.2 1-phase mains connecon 120 V 624
15.2.1 Rated data 624
15.3 1-phase mains connecon 230/240 V 625
15.3.1 Rated data 625
15.4 3-phase mains connecon 230/240 V 626
15.4.1 Rated data 626
15.5 3-phase mains connecon 400 V 627
15.5.1 Rated data 627
15.6 3-phase mains connecon 400 V "light duty" 628
15.6.1 Rated data 628
15.7 3-phase mains connecon 480 V 629
15.7.1 Rated data 629
15.8 3-phase mains connecon 480 V "Light Duty" 630
15.8.1 Rated data 630
16 Appendix 631
16.1 Operate and parameterise the inverter with keypad 631
16.1.1 Keypad operang mode 632
16.1.1.1 Keypad status display 632
16.1.1.2 Funcon of keypad keys in operang mode 633
16.1.1.3 Error reset with keypad 634
16.1.2 Keypad parameterisaon mode 635
16.1.2.1 Parameter groups 635
16.1.2.2 Funcon of the keypad keys in the parameterisaon mode 636
16.1.2.3 Save parameter sengs with keypad 637
16.1.2.4 Display of status words on keypad 638
16.2 Error codes 639
16.3 Parameter aribute list 659
Contents
14