Safety instructions
General safety instructions for drive components
2
9
Lenze ¯ BA 33.0005 ¯ 5.0
Storage conditions
¯ Up to one year:
– Shafts and uncoated surfaces are delivered in a protected against rust status.
Aftertreatment is required where the corrosion protection has been damaged.
¯ More than one year, up to two years:
– Apply a long−term corrosion preventive (e.g. Anticorit BW 366 from the Fuchs
company) to the shafts and uncoated surfaces before storing the motor away.
Transport
Before transport
¯ check that all component parts are safely mounted;
¯ check that all component parts with a loose fastening are secured or removed;
¯ tighten all transport aids (eye bolts or support plates).
Use an appropriate means of transport and lifting equipment! ( 20)
Stop!
Danger by toppling or falling loads!
Observe payloads!
¯ The payload of the hoists and load handling devices must at least
correspond to the weight of the load, for weights see the catalogue.
¯ Secure the load so that it will not topple or fall down.
¯ Walk under suspended loads prohibited!
Danger!
Completely screw in transport aids (such as eye bolts or bearing plates),
they must be flat and applied over their entire surface!
If possible, the transport aids (such as eye bolts or bearing plates) must
be stressed vertically in the direction of the screw axis! Angular tension or
tension to the sides reduces the payload! Observe the information
provided in DIN 580!
Use additional appropriate lifting aids, if required, to achieve a direction
of loading which is as vertical as possible (highest payload). Secure lifting
aids against shifting!
Corrosion protection
Lenze offers paints with different resistance characteristics for drive systems. Since the
resistance may be reduced when the paint coat is damaged, defects in paint work (e.g.
through transport or assembly) must be removed professionally to reach the required
corrosion resistance.
Mechanical installation
¯ Provide for careful handling and avoid mechanical overload. During handling
neither bend components, nor change the insulation distances.
To Next Page
Loading...
Need help?
General
