Mechanical installation
Assembly of built−on accessories
5
23
Lenze ¯ BA 33.0005 ¯ 5.0
5.4 Assembly of built−on accessories
Follow these instructions carefully. Please note that the warranty and product liability
will become void in the event of impermissible alterations or modifications to the
motors.
¯ Mount the transmission elements:
– Shocks and impacts must be avoided! They could destroy the motor.
– For mounting always use the centre bore in the motor shaft as specified by DIN
332−DR−M...
– Tolerances of the shaft ends:
£ Æ 50 mm: ISO k6, > Æ 50 mm: ISO m6.
¯ Only use an extractor for the disassembly.
¯ When using belts for torque/power transmission:
– Tension the belts in a controlled manner.
– Provide protection against accidental contact! During operation, surface
temperatures of up to 140°C are possible.
To Next Page
Loading...
