3
Pre-Treatment
42
PB1
2021-10-25
S023735
3. Hold the center of the ball joint in the area shown and remove the top fastener from the link
rod - anti-roll bar - front and move the top to one side for access.
4. Remove the two fasteners from the lower spring and strut - front suspension.
5. Move and support the stub axle - front for access.
6. Remove the plenum cover.
7.
NOTE
You must have the aid of one more person for the next step.
Person one will remove the three fasteners from the top mount - front suspension damper.
Person two will hold and remove the spring and strut - front suspension.
To Next Page
Loading...
