Pre-Treatment - First Steps
2
S023735 PB1
2021-10-25
11
High Voltage Battery - Removal
Before starting this task:
DANGER
You must isolate the battery - 12V and the battery - high voltage before you continue
with this procedure. If you do not isolate the battery - 12V and the battery - high
voltage, it can cause injury, or damage to the vehicle.
WARNING
This procedure must only be done by approved personnel.
WARNING
You must isolate the battery - 12V and the battery - high voltage before you
continue with this procedure. If you do not isolate the battery - 12V and the
battery - high voltage, it can cause injury, or damage to the vehicle.
WARNING
This is a high voltage component. Do not disassemble the component. If there
is damage to the component, or it is defective, you must replace the full
assembly.
1. Drain the coolant - high voltage battery system.
Disconnect the hose - coolant from the right side of the battery - high voltage and collect the
coolant.
Repeat this for the hose - coolant on the left side of the battery - high voltage.
To Next Page
Loading...
Need help?
General
