Use fixed IP address
To setup static IP address, select “Use fixed IP address” and move the cursor
to the IP address blank (as indicated below) and insert the new IP address, ex.
192.168.7.123; then go to the Default gateway (explained latter) blank and
change the setting, ex. 192.168.7.254. Press “Save” to confirm the new setting.
When using static IP address to login to the IP Camera, users can access it
either through “DeviceSearch” software (see 4. Accessing Camera) or input the
IP address in the URL bar and press “Enter”.
• IP address
This is necessary for network identification.
• Subnet mask
It is used to determine if the destination is in the same subnet. The
default value is “255.255.255.0”.
To Next Page
Loading...
