Parameter description:
VID:
VLAN identifier. Each tag-based VLAN group has a unique VID. It
appears only in tag-based mode.
Member:
In modify function this is used to enable or disable if a port is a member
of the new added VLAN, “Enable” means it is a member of the VLAN.
Just tick the check box () beside the port x to enable it.
Port:
Port number.
VLAN aware Enabled:
Discard other VLAN group packets, only forward this port joined VLAN
group packets.
Packet Type:
All:
Forward all tagged and untagged packets.
Tagged Only:
Forward tagged packets only and discard untagged packets.
Pvid:
This PVID range will be 1-4094. Before you set a number x as PVID,
you have to create a Tag-based VLAN with VID x. For example, if
port x receives an untagged packet, the switch will apply the PVID
(assume as VID y) of port x to tag this packet, the packet then will
be forwarded as the tagged packet with VID
To Next Page