Page 57
SERIAL 3 FUNCTION
The “Serial 3 Function” by default is set to UPB to utilize HLC Lighting. When using HLC, plug the LEVITON Powerline
Interface Module (PIM) into the third built-in serial interface (J3 Serial) on the OmniPro II controller. To change the “Serial 3
Function”, select the function for the built-in serial interface from the list.
SERIAL 4 - SERIAL 5 FUNCTION
The "Serial 4 Function" and "Serial 5 Function" selects the communication protocol used for the built-in serial interface ports (J4
Serial and J5 Serial, respectively) on the OmniPro II controller. Select the function for the built-in serial interface from the list.
Notes about audio distribution systems:
1. OmniPro II only supports communications with one audio distribution system: LEVITON Hi-Fi, NuVo Concerto, NuVo
Grand Concerto, NuVo Essentia/Simplese, Russound, Xantech, Speakercraft, or Proficient. Do not configure more than
one audio protocol.
2. When connecting the Speakercraft audio system to the OmniPro II:
a. The Speakercraft RSA 1.0 MZC Control Interface Module must be used.
b. Use the LEVITON Model 21A05-2 Serial PC Cable for making the connection.
c. In order for the key presses to perform the correct operation, an MKP keypad must be assigned to address zero
in each zone.
3. When connecting the Proficient audio system to the OmniPro II:
a. Use the LEVITON Model 21A05-2 Serial PC Cable for making the connection.
b. In order for the key presses to perform the correct operation, a PMK keypad must be assigned to address zero in
each zone.
4. When connecting the NuVo Concerto, NuVo Essentia, NuVo Simplese, Russound CAV or CAM, or Xantech MRC-88
audio system to the OmniPro II, use the LEVITON Model 36A05-4 Serial Connectivity Cable for making the
connection.
5. When connecting the NuVo Grand Concerto audio system to the OmniPro II, an RS-232 Line Booster or Optical Isolator
must be used. See the following Knowledge Base article for additional information and wiring diagram:
http://kb.homeauto.com/default.asp?id=849&SID=&Lang=1.
SERIAL 6 RATE
"Serial 6 Rate" selects the baud rate used when a Serial Interface Module is added to the OmniPro II system. If a Serial Interface
Module is installed, select its baud rate then press the ' # ' key.
To Next Page
