Levo COMP ALLOY - Chain Guide; Stem; 0000159790

9
6.6. STEM
Some Levo models are equipped with an Alloy Trail Stem.
WARNING! The stem is designed with no gap between the stem body and the
faceplate at the upper bolt area. The upper bolts must be tightened such that the
faceplate bottoms out against the stem body before being torqued. Failure to
bottom out the faceplate against the stem body can result in structural damage to
the handlebar.
A
B
6.3
Fig. 6.3
 Install the stem on the steerer tube, followed by the top cap and bolt (A), then tighten the
top cap bolt.
 Align the stem with the front wheel and torque the rear stem bolts (B) to specification.
6.5. CHAIN GUIDE
5 MM
A
B
6.2
Fig. 6.2
Setting the chain guide position:
 Shift to the lowest gear.
 Rotate the outer chain guide face upwards (A).
 Loosen the chain guide bolt (B) with a 5 mm hex key and align the lower edge of the inner
chain guide face to 5 mm above the chain.
 Tighten the chain guide bolt (B) to 4.5 Nm 40 in-lbf.
 Rotate the outer chain guide face downwards (A) and locate it into position.