Levoit LV-H126 - Getting Started; How to Use Your Air Purifier

6
EN
GETTING STARTED
Figure 1.1
Figure 1.3
Figure 1.2
1. Carefully remove your air purifier from the box and bag.
2. Remove the rear cover by pressing the top tab down.
[Figure 1.1] Then, lift o the rear cover.
3. Take the filters out of the purifier. Remove the filters
from their plastic packaging.
4. Place the black pre-filter on top of the white HEPA filter.
Make sure the white pull tabs are folded over the pre-
filter.
5. Place the filters back into the air purifier. The
pre-filter and pull tabs should be facing out.
[Figure 1.2]
6. Replace the rear cover.
a. Make sure the side with the filter reminder wheel
is facing out.
b. Insert the cover’s feet into the matching slots in
the back of the air purifier. [Figure 1.3]
c. Press the rear cover into the housing until the
latch clicks.
7. Place your air purifier on a flat, stable surface, such as
a table.
NOTE:
• We recommend allowing 38 cm (15 inches) of clearance on all
sides of the purifier. [Figure 1.4]
• Do not place anything on top of your air purifier.
Figure 1.4
38 cm
pull tabs
facing out