6
GETTING STARTED
Figure 1.1
Figure 1.3
Figure 1.2
1. Remove the rear cover by pressing the top tab
down. [Figure 1.1] Remove the rear cover.
2. Remove the filters from their plastic packaging.
3. Place the Pre-Filter on top of the Personal HEPA
filter. Make sure the pull tabs are folded over the
Pre-Filter.
4. Place the filters back into the air purifier. The pre-
filter and pull tabs should be facing out. [Figure 1.2]
5. Replace the rear cover.
a. Make sure the side with the filter reminder
wheel is facing out.
b. Insert the cover’s feet into the matching slots
in the back of the air purifier. [Figure 1.3]
c. Press the rear cover into the housing until the
latch clicks.
6. Place your air purifier on a flat, stable surface, such
as a table.
pull tabs
facing out
HOW TO USE YOUR
AIR PURIFIER
1. Turn on your air purifier by turning the control knob
to 1, 2, or 3.
Mode
Speed
1
Low
2
Medium
3
High
2. Turn o your air purifier by turning the control knob
to “OFF”.
To Next Page
Loading...
Need help?
General
