Levoit LV-PUR131S - Controls and Indicators; Air Purifier Button Functions; WiFi and Air Quality Status Lights

7
GETTING STARTED
1. Open the filter cover of the air purifier
and remove both filters from their plastic
packaging. [Figure 1.1]
2. Place the High-Eciency Activated
Carbon Filter back into the air purifier,
followed by the Fine Preliminary/True
HEPA Combination Filter. Make sure the
pull tabs on both filters are facing out.
[Figure 1.2]
3. Replace the filter cover by lining up
the cover’s feet with the slots in the
bottom of the housing. Make sure that
the triangular piece at the bottom of
the cover is touching the safety switch.
[Figure 1.3]
4. Push the cover closed.
5. Place the air purifier on a hard,
flat surface. Leave 15 in / 38 cm of
clearance on all sides of the air purifier.
[Figure 1.4]
Note: Do not remove the foam piece
attached to the dust sensor cover
unless instructed by Customer Support.
[Figure 1.5]
Figure 1.1
Figure 1.4
Figure 1.5
Figure 1.2
Figure 1.3
Tabs facing
outward
15 in /
38 cm
Safety
switch
15 in /
38 cm