7
CONTROLS & DISPLAY
On/O Button
• Tap to turn the humidifier
on/o.
• Press and hold for 5 seconds
to pair with the VeSync app.
See the in-app instructions
for more information.
• Press and hold for 15
seconds to reset the
humidifier. This will restore
the humidifier’s default
settings and disconnect it
from Wi-Fi® and the VeSync
app (see page 11).
Display Lock Button
• Press and hold for 3
seconds to turn Display
Lock on. will show on the
display.
• will flash 3 times when
any other button is tapped
to indicate that Display Lock
is on.
• Press and hold for 3
seconds to turn Display
Lock o.
• You can also turn the Display
Lock on/o in the VeSync
app.
Humidity Level Button
• Tap to set a target humidity
level from 30–60% that’s
used with Auto Mode.
• Continue tapping to cycle
through target humidity
options in increments of 5%.
• You can also change the
target humidity level in the
VeSync app (see page 14).
Fan Speed Button
• Tap repeatedly to cycle
through fan speed settings:
low, medium, and high.
Timer Button
• Tap to set a timer for 1–12
hours.
• Press and hold for 2 seconds
to begin cycling through
the timer options in 1-hour
increments.
• After a timer is set, the
display will flash 3 times,
then show a countdown until
the timer is finished.
• To turn a timer o before it
is finished, tap until the
display shows “– –” or tap
to turn the humidifier o.
Display O Button
• Tap to turn the display o.
• Tap any button (except )
to turn the display on. If no
other button is pressed after
6 seconds, the display will
automatically turn o again.
Note: You can also use the VeSync app to control these functions, as well as additional app-only features
(see VeSync App Functions, page 14).
Auto Mode Button
• Tap to turn Auto Mode on
(see page 12).
• Tap , , or to exit
Auto Mode and resume
manual controls, or tap
for Sleep Mode.
• You can also turn Auto Mode
on/o in the VeSync app.
To Next Page
Loading...
