EN
21
Cleaning the Dust Sensor
dry place to avoid moisture damage.
Storage
It is recommended to clean the AirSight™
Infrared Dust Sensor lens every 2 months
If the Air Quality Indicator is red (indicating
“Bad” air quality) more than usual, you may
need to clean your dust sensor.
Note: How often you clean the dust sensor
will depend on the air quality of your
environment. If your air is often polluted with
dust, dander, smoke, and other particles,
you may need to clean your dust sensor
more often.
Note: Do not remove the foam piece
attached to the dust sensor cover
unless instructed by Customer Support.
[Figure 3.3]
Open the dust sensor cover. [Figure 3.1]
Figure 3.1
Figure 3.2
Figure 3.3
Use a cotton swab dipped in water to
clean the dust sensor lens. [Figure 3.2]
Wipe the lens dry with a dry cotton swab.
Replace the dust sensor cover.
Do not
remove
To Next Page
Loading...
