Levolor Cellular Shade Series - Adjusting the Day;Night Middle Rail; Attach Magnetic Hold-Down Brackets (Optional)

8
INSTALLATION
INSTALLATION
Adjusting the Day/Night Middle Rail
■
Hex bolts are found at the ends of the exposed middle rail.
■
Insert the rail adjust key so that its hex-shaped portion is about halfway into the pocket.
■
Turn the key clockwise to raise that end of the rail or counter-clockwise to lower it.
➤
One full turn of the key equals approximately
1
⁄ 8 ”.
IMPORTANT: When adjusting bolts on one side, turn all the bolts at the other side in
the same amount.
■
On shades over 60” wide, there will be two hex pockets in the right end of the middle rail.
Use the rear hex pocket to adjust the tension in the center cord after adjusting the outer
cords to level the rail.
Attach Magnetic Hold-Down Brackets (Optional)
Hold-down brackets provide stability and prevent swaying by securing the bottom rail, for example on French door applications.
Hold-down brackets can only be used on outside mount shades.
Check the Magnet Polarity
■
Place the magnetic hold-down bracket near one end of the bottom rail.
➤
The magnet should attract to the magnet that is already in the bottom rail.
➤
If the magnet in the bracket is repelled by the magnet in the rail, reverse the polarity of the magnet as described in "Reverse
Bracket Magnet Polarity (If Needed)".
Reverse Bracket Magnet Polarity (If Needed)
The magnet within the magnetic bracket must be attracted to the magnet located within the bottom rail. In the event that they
repel each other, the magnet within the magnetic bracket can be removed and flipped.
■
To remove the magnet, hold a small steel flat blade screw- driver up to the magnet in the bracket and pull the magnet out with
the screwdriver.
■
Then flip the magnet over and place it back into the bracket.
Mark the Bracket Location
■
Lower the shade to the closed position.
■
Mark the location on the door where the bracket will be placed.
Raise
Lower