EasyManua.ls Logo

Levolor Cellular Shade Series - Care; Remove the Shade, If Necessary; Cleaning Procedures

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
INSTALLATION
CARE
Remove the Shade, If Necessary
Lower the shade approximately 4".
While holding the headrail, push back on the bottom tab of the
installation bracket with a flat head screwdriver to release the
bottom of the headrail.
Then roll the back of the headrail down and out from the bracket.
Cleaning Procedures
LEVOLOR
®
PREMIER
Cellular Shades are made of anti-static, dust-resistant fabric which repels dirt and dust. For most cellular
fabrics, the following cleaning options are available.
Dusting
Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
Vacuuming
CAUTION: Do not vacuum Oceanside.
For deeper cleaning, vacuum gently with a brush attachment.
Compressed Air/Hair Dryer (Cool Setting)
Use compressed air or a hair-dryer on a cool setting to blow dust and dirt off shades.
Spot-Cleaning
CAUTION: Do not spot-clean Harmony, Naturelle, Oceanside, or Sonora.
Prepare a solution of warm water and a mild detergent.
Dampen a clean cloth in the solution and wring it out.
Dab the spot with the dampened cloth until it is removed. Do not rub the fabric.
Allow the shade to dry in the completely lowered (or closed) position.
Ultrasonic Cleaning
CAUTION: Do not ultrasonically clean any room-darkening fabric.
Specify that a mild detergent solution be used.
IMPORTANT: Never immerse the headrail into the solution.
Dry the shade completely in the lowered (or closed) position.
Injection/Extraction Cleaning
This type of professional cleaning injects a cleaning solution into the fabric and extracts the dirty solution in the same motion.
Use only the dry method of injection/extraction for Oceanside fabrics.
If using injection/extraction for Harmony or Naturelle, specify water only; no chemicals.
Leave shades in closed position (stacked) for at least 15 minutes after cleaning.
Headrail Cleaning
CAUTION: Never use abrasive cleaning methods or harsh chemicals.
Dampen a soft, clean cloth in warm water and wring it out.
Gently wipe the headrail to remove dirt and dust.
Headrail
Bracket
Back of
Shade
Remove
Bottom
Tab

Related product manuals